 ======================================================================
                 REPLACEMENT DOSSWAP.EXE FOR MS-DOS 5.0
 ======================================================================
                                                    Revision Date: 6/91
 --------------------------------------------------------------------
 | INFORMATION PROVIDED IN THIS DOCUMENT AND ANY SOFTWARE THAT MAY    |
 | ACCOMPANY THIS DOCUMENT (collectively referred to as an            |
 | Application Note) IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY      |
 | KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO    |
 | THE IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A     |
 | PARTICULAR PURPOSE. The user assumes the entire risk as to the     |
 | accuracy and the use of this Application Note. This Application    |
 | Note may be copied and distributed subject to the following        |
 | conditions: 1) All text must be copied without modification and    |
 | all pages must be included; 2) If software is included, all files  |
 | on the disk(s) must be copied without modification (the MS-DOS     |
 | utility DISKCOPY is appropriate for this purpose); 3) All          |
 | components of this Application Note must be distributed together;  |
 | and 4) This Application Note may not be distributed for profit.    |
 |                                                                    |
 | Copyright 1991 Microsoft Corporation. All Rights Reserved.         |
 | Microsoft, the Microsoft logo, and MS-DOS are registered           |
 | trademarks and Windows is a trademark of Microsoft Corporation.    |
  --------------------------------------------------------------------
  
 Introduction
 ------------
  
 The disk provided with this application note contains DOSSWAP.EXE, a
 replacement for the DOSSWAP.EXE file that is included with MS-DOS
 version 5.0. The replacement file corrects a problem in the original
 DOSSWAP.EXE file that caused the task swapper in MS-DOS Shell to fail
 when attempting to swap out of some programs.
  
 Replacing DOSSWAP.EXE
 ---------------------
  
 1. Insert the enclosed "Replacement DOSSWAP.EXE for MS-DOS 5.0" disk
    in floppy disk drive A.
  
 2. At the DOS prompt, type the following command and press ENTER
  
       copy a:\dosswap.exe <destination>
     
    where <destination> is the drive and directory where your MS-DOS
    files are located. For example, if your MS-DOS files are located in
    the DOS directory on drive C, type the following command:
  
       copy a:\dosswap.exe c:\dos
  
     Note: If you are copying DOSSWAP.EXE from a drive other than A,
     substitute the appropriate drive letter for "a" in the above
     command.
    
 3. A message will be displayed stating: "1 file(s) copied." This
    indicates your DOSSWAP.EXE file has been successfully replaced.
  
